AXIAL SCX10 III Front and Rear CVD Drive Shaft Upgrade SCX3L037SA by GPM  [SCX3L037SA]

High strength CVD shafts for Axial SCX10 III JT

This front and rear constant velocity drive shaft set is made for AXIAL Racing SCX10 III JEEP JT GLADIATOR crawlers and pairs alloy 6061 T6 with hardened steel components to deliver improved torsional strength while retaining a convincing scale look. The CVD swing joint geometry keeps drive power steady through extreme articulation typical of 1/10 scale rock crawlers.

Installation notes: these CVDs replace factory dogbones or fragile plastic links and install at both axle outputs and the transmission where CVD hardware is used. Ensure axle hex clearance and pin retention are correct before tightening. Apply light thread locker on steel fasteners only where required and check full suspension travel for rubbing before final assembly.

Tuning role: moving to mixed alloy and steel CVDs helps resist high torque from modified motors and aggressive crawler setups, reduces driveline lash, and delivers crisper low speed control. When upgrading, inspect splines, wave shims, and bearings for wear to ensure long term reliability.

This GPM-produced CVD drive shaft set is a straightforward drivetrain upgrade for AXIAL SCX10 III JEEP JT GLADIATOR models looking for more durable power transfer; verify fitment before final installation.