Axial SCX10 II Steel Transmission Gear Shaft SCX27038SG by GPM  [SCX27038SG]

AXIAL Racing SCX10 II Steel Transmission Gear Shaft - 1set (For SCX10 90037, SCX10 Ii 90047, Smt10 90055, 90057) - GPM SCX27038SG
Price:
CAD$20.94
Brand:
GPM
Model:
SCX27038SG
GTIN:
4894538263596
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Axial SCX10 II Replacement Gear Shaft

This steel transmission gear shaft is a single-set replacement made for Axial SCX10 II platforms. It is offered to match the original fit where compatibility is listed, providing a direct replacement for worn or damaged drivetrain shafts without modifying the gearbox geometry.

Installation notes: access the axle or gearbox as required for your SCX10 chassis, transfer any spacers or bearings from the original shaft, fully seat the new shaft and check gear mesh and bearing alignment before driving. This component is a mechanical drivetrain part intended for repair, maintenance or tuning setups.

Compatible Models

  • SCX10 90037
  • SCX10 Ii 90047
  • Smt10 90055
  • 90057

Will this shaft fit my SCX10 II chassis?

Confirm your vehicle code before ordering; this shaft is listed as compatible with SCX10 90037, SCX10 Ii 90047, Smt10 90055 and 90057 chassis codes.

Do I need special tools to install it?

Basic hobby tools are sufficient: small sockets, hex drivers and a bearing press or gentle tapping to seat bearings and spacers as required.

What checks should I do after fitting?

Verify smooth rotation at low speed, recheck gear mesh and bearing preload, and inspect for any binding before full-speed runs.

Copyright © 2008-2026 rcjaz.ca All rights reserved