This set provides RC-scale exterior step bars made for AXIAL Racing SCX10 II platforms. The pieces are machined from aluminium and carry a fine engraved checkerplate pattern for authentic scale visuals. The surface finish is an anodized silver over an underlying anodized blue layer, creating a subtle dual-tone appearance as described by the manufacturer.
These bars are intended as cosmetic side steps and accessory mounting points for scale trail rigs, not as structural chassis reinforcements. The parallelogram profile is shaped to follow common SCX10 II body lines while keeping clearance for tyres and full suspension travel.
Fitment notes: the pair mounts to body and side-mount locations using countersunk hardware for a clean, low profile fit. The pack includes 3x14 stainless flat head screws and 3mm countersink shims to help align the bars with typical body mounting holes, cutting down on extra fasteners.
Fit these aluminium step bars to boost the scale look of an SCX10 II build, check body alignment during installation, and confirm tyre clearance before hitting rough terrain.
Copyright © 2008-2026 rcjaz.ca All rights reserved