This 4pcs set of stainless steel king pin screws is made for the AXIAL Racing SCX10 II front knuckle on RC-scale crawlers. The fasteners serve as replacement hardware for the front-knuckle king pin mounting and are supplied as a matched set so both sides share consistent fit and function.
Material: stainless steel, offering basic corrosion resistance suited to hobby crawler use. This material improves longevity compared with standard plated fasteners but does not guarantee permanent corrosion protection; inspect parts after extended wet or abrasive running.
Dimensions provided from the source: neck diameter 3.97mm, thread diameter 3mm, total length 10.5mm. Confirm these measurements against your existing screws before installation to ensure correct thread engagement and fit in the front knuckle.
Installation notes: replace all four screws at once when servicing the front knuckle, start each screw by hand to avoid cross-threading, and tighten until secure without over-torquing to protect knuckle threads. These screws are intended for RC-scale model use only.
Copyright © 2008-2026 rcjaz.ca All rights reserved
