AXIAL SCX10 II +3mm Aluminum Hex Hub Set SCX2010D+3MM by GPM  [SCX2010D+3MM]

Performance summary

Forged aluminum hex hubs built for AXIAL SCX10 II chassis, intended as a direct aftermarket swap to move each wheel 3mm outward from a 5mm reference. The parts work with front and rear wheel shafts to preserve steering smoothness while increasing track width for improved scale stability.

Key functional notes drawn from the product details:

• Widened track: the hub profile increases overall offset to 8mm relative to the original 5mm baseline, helping lateral stability on technical trails and scale courses.
• Secure mounting: hub geometry is formed to clamp the wheel hex and reduce rotary play under load, supporting better climbing control.
• Finish and form: metallic surface with swirl engraving on the outer ring gives a scale-ready appearance while remaining a functional upgrade.

Included items are listed from the product data, use them as supplied to secure the hubs:

• Brake Disk - 2 pcs
• M4x2x12 Stainless Steel Pin - 2 pcs

Installation and tuning role: these hubs mate to the AXIAL SCX10 II wheel and axle interfaces as an aftermarket component to alter wheel stance and track width. Once installed they serve as the main wheel mounting point and a tuning element for cornering and climbing behaviour; always confirm wheel hex and axle fit before final assembly.