Axial SCX-10 Honcho Rear Lower Chassis Linkage 130mm - ASCX10-22474-BK by Jazrider  [ASCX10-22474-BK]

Rear lower link - SCX-10 Honcho (130mm)

This ASCX10-22474-BK is an aluminum rear lower chassis linkage sized 130mm and finished in black, offered as an RC-scale replacement or upgrade specifically for the Axial Racing SCX-10 Honcho chassis. It is intended to serve as a direct-fit rear lower link to restore geometry or to provide a durable replacement part for trail and scale crawling setups.

Compatibility and fitment: the part is described for use with Axial Racing SCX-10 Honcho models; verify existing link length and mount spacing on your chassis before installation. The 130mm dimension refers to the linkage length as supplied, intended to match the Honcho rear lower link position.

Installation notes: this component is a like-for-like link replacement, so standard link fasteners and mounting hardware from the SCX-10 Honcho are typically reused. Inspect threaded holes and hardware condition during swap, ensure secure mounting at both chassis and axle ends, and confirm suspension droop and travel after fitting to maintain intended handling.

Tuning role: a firm aluminum lower link stabilizes rear chassis geometry under load, affects roll behaviour and tyre scrub characteristics, and pairs with shock and upper link settings during setup. Use it when you need a consistent, wear-resistant lower link to preserve alignment and to reduce flex compared with softer materials.