Axial SCX-10 Honcho & Dingo Steering Block & Linkage Upgrade - ASCX10-22403-GR by Jazrider  [ASCX10-22403-GR]

Axial Racing SCX-10 Honcho & Dingo Aluminum Steering Block & Linkage (Green)
Price:
CAD$20.24
Brand:
JAZRIDER
Model:
ASCX10-22403-GR
Condition:
Brand New
Write a review

Aluminum steering upgrade for SCX-10 Honcho and Dingo

This green anodized aluminum steering block and linkage set is built for Axial SCX-10 Honcho and Dingo scale crawlers and supplied under model ASCX10-22403-GR. The components are intended as metal replacements for the stock plastic steering block and linkages, relocating hardware to aluminum hardpoints and providing a corrosion-resistant finish.

Compatibility is limited to the SCX-10 Honcho and Dingo designations listed in the product name; do not assume fitment on other SCX-10 variants without checking mount dimensions. These parts give hobbyists a straightforward way to replace common plastic wear points with serviceable metal pieces.

Installation uses the vehicle's existing steering mounting points and keeps original alignment and throw characteristics. Confirm link lengths and ball stud positions during assembly to prevent binding, and make small incremental adjustments while setting steering geometry.

How do I install this on my Honcho?

Fit the aluminum block and linkage using the stock steering mount points; remove the plastic parts and transfer or replace the ball studs and screws as required. Verify the link lengths before final tightening.

Is mounting hardware included?

The listing does not itemize included hardware, so plan to reuse the vehicle's original screws and ball studs or source compatible M3 hardware if needed.

Any tips to avoid steering bind after fitment?

Set ball stud heights and link lengths in small steps, check for full travel at each end, and confirm the servo horn is centered before final assembly to prevent binding.

Copyright © 2008-2026 rcjaz.ca All rights reserved