Axial SCX10 14mmx9mm Alloy Hex Adapter - AX010/14X9MM by GPM  [AX010/14X9MM]

14mmx9mm alloy wheel hex for SCX10 series

This 4-piece hex adapter set is made for Axial Racing platforms and converts standard wheel interfaces to a 14mmx9mm hex pattern using model AX010/14X9MM. The adapters are supplied as a matched set for one axle and suit EXO, SCX10 and Wraith scale crawlers.

In use the adapters act as the mechanical interface between wheel hubs and wheels, preserving wheel position and alignment when fitting aftermarket wheels or changing hub offsets. The components are alloy construction and intended for model-level wheel mounting on trail rigs and crawlers.

Installation notes: ensure full hex engagement and seat the adapter flush to the hub before tightening. Use the correct hex driver for the wheel screw, check for any play after the first run, and re-torque fasteners after a short shakedown. If you use threadlocker, apply as you normally would for wheel fasteners.

Tuning role: these low-profile adapters let you fine-tune wheel fitment and track width in small steps, handy when swapping beadlock or custom wheels to clear suspension or bodywork on EXO, SCX10 and Wraith chassis.