Axial Racing Yeti XL Rear Steel #45 Axle with 8mm Wheel Hex - YTL169RS8 by GPM  [YTL169RS8]

Axial Racing Yeti XL Steel #45 Rear AXLE With 8mm Wheel Hex(AX31085) - 1set - GPM YTL169RS8
Price:
CAD$38.53
Brand:
GPM
Model:
YTL169RS8
GTIN:
4894538246445
Condition:
Brand New
Write a review

Replacement rear axle for Yeti XL

This rear axle is a single-set replacement intended for Axial Racing Yeti XL models, supplied as one set. Constructed from steel #45 and fitted with an 8mm wheel hex interface, it is sized to match common Yeti XL wheel fitment for straightforward interchange and basic drivetrain tuning.

Installation notes: confirm your axle bore and wheel hex dimensions before fitting, keep original shims or spacers during reassembly, and check driveshaft engagement once installed. Use this axle as a wear-item replacement or when you want firmer wheel mounting and repeatable alignment on scale off-road runs.

Specifications

  • Item Axial Racing Yeti XL Steel #45 Rear AXLE With 8mm Wheel Hex (1 set)
  • Material Steel #45
  • Model Number YTL169RS8
  • Compatibility AX31085, Axial Racing Yeti XL

Fit this axle when replacing worn rear assemblies or when seeking a tougher steel option for consistent wheel mounting during aggressive scale off-road use.

Will this fit the stock Yeti XL rear housing without modification?

It is designed for Axial Racing Yeti XL and references AX31085, but you should measure your axle bore and wheel hex to confirm a direct swap before installing.

What routine checks should I do after fitting the axle?

Verify axle seating and driveshaft engagement, ensure retention hardware is secure, and inspect bearings and spacers for wear after the first few runs.

Can I use standard 8mm aftermarket hexes with this axle?

Yes, the axle uses an 8mm wheel hex interface; confirm spline fit and the retention method match your hub or wheel set before relying on aftermarket hexes.

Does the steel axle change vehicle handling due to extra weight?

Steel usually adds rotating mass compared with some alloy or composite parts, which can affect inertia but typically improves durability and wheel mounting consistency for scale off-road rigs.

Copyright © 2008-2026 rcjaz.ca All rights reserved