Axial Racing Yeti Rear Upper Chassis Link Aluminium with Plastic Ends - YT014RP by GPM  [YT014RP]

Aluminium rear upper link for Yeti chassis

This is an RC-scale rear upper chassis link made for the Axial Racing Yeti platform, supplied as 1pr. The design uses an aluminium centre section with plastic end fittings to connect to the existing link mounts on the chassis.

The part replaces the stock rear upper link assembly and is intended for suspension geometry and handling adjustments. Installation is a direct swap: remove the original rear upper links, transfer any reusable hardware or bearings if required, and fit the replacement link into the same mounting points. No special adapters are needed on a standard Yeti chassis.

For setup and upkeep, check that the link runs freely through the suspension travel, verify alignment, ensure end fittings are tight, and inspect attachment points for any play after initial testing. Use common RC hand tools and retain the original torque values for chassis fasteners.