Axial Racing Yeti 2.2 Wheel Hub Adapters 22mm Aluminium - YT022A by GPM  [YT022A]

Yeti 22mm aluminium hub sleeve overview

This pair of machined aluminium wheel hub adapters is made for use with Axial Racing Yeti 2.2 wheel setups and provides a fixed 22mm spacer to adjust wheel offset and tyre clearance without altering hub or axle geometry. The set is supplied as matched left and right pieces to preserve alignment while you tune ride height and drivetrain geometry.

Installation is simple: the adapters fit between the wheel hex and the hub flange and use the existing wheel mounting hardware and alignment points. By moving the tyre line outwards they change effective track width, which helps when fitting wider tyres, correcting stance, or avoiding suspension and bodywork rub on scale rock racers.

Aluminium is chosen for a practical stiffness-to-weight balance so unsprung mass stays low while the material resists deformation under clamp loads. These adapters are intended as aftermarket tuning accessories for RC-scale adjustment and setup work.

Fit these adapters when you need a durable, machined spacer to correct wheel offset or to gain tyre clearance on Axial Yeti 2.2 builds; always check torque and trial-fit before extended running.