Axial Racing Wraith Aluminum C Hub Carrier Upgrade - AW-23012-S by Jazrider  [AW-23012-S]

This aluminum C hub carrier is manufactured for the Axial Racing Wraith range and comes in a silver finish as a scale replacement or upgrade. It replaces standard plastic hubs and mounts as the steering knuckle support on the front suspension, offering increased wear resistance for trail and rock crawling use.

As a direct-replacement item for Wraith chassis layouts, the carrier retains the original mounting points and wheel hex orientation so it installs without modifying the axle or wheel fitment while improving durability in demanding off-road conditions.

Installation tips: check left and right orientation before final tightening, consider reusing original hardware if threads and condition are acceptable, and confirm the hub and wheel spin freely after installation. Adjust toe and steering endpoints on your transmitter or linkage where required to restore handling balance.

Maintenance notes: inspect fasteners after early runs for looseness, look for binding at the knuckle-to-axle interface, and service or replace bearings and pins as routine upkeep. Switching to an aluminum carrier can change steering feedback slightly, so fine-tune steering and suspension settings after fitting.