AXIAL Racing SMT10 Aluminium Wheel Hex +2mm - MJ0102/+2MM by GPM  [MJ0102/+2MM]

Aluminium SMT10 wheel hex for wider track

This machined aluminium wheel hex is made for AXIAL Racing SMT10 chassis and is supplied as a 2pcs set with a +2mm offset to widen track without changing wheel backspacing. It is designed for hobby use on model cars and to let you fine tune wheel position and handling on the SMT10 platform.

Design and role: the hex alters the wheel mounting stance so you can make small track width adjustments for setup or clearance needs. Being machined aluminium, it provides firmer wheel retention than standard plastic hexes and helps keep alignment under load during model driving and course use.

Installation notes: swap the factory wheel hex for these aluminium units using your existing axle and wheel hardware on SMT10 layouts. After fitting a +2mm offset, check tyre clearance and suspension travel, hand-tighten components then torque to your usual wheel hardware practice. Not intended for real vehicle use.

Included hardware: the package supplies the wheel hexes plus the small fitting parts commonly needed during installation, listed here for clarity: 2pcs wheel hex, 2x10.9 steel pin - 2pcs, 2x7 steel pin - 2pcs, 2.5x2.5 screw shaft - 4pcs, 1.2 hex socket key - 1pc.