Axial Racing SCX-10 Rear Axle Assembly ASCX10-22115X by Jazrider  [ASCX10-22115X]

This RC-scale rear axle assembly is designed for use on Axial SCX-10 chassis and is supplied as a pre-assembled aluminum rear axle unit. It is offered as a replacement or service component for scale rock crawlers, with an emphasis on fitment clarity and straightforward serviceability.

Installation notes: the unit ships pre-assembled to reduce the number of disassembly steps required during fitting. When installing on an SCX-10 chassis, confirm axle orientation and tighten mounting hardware to the torque values called out in your SCX-10 manual. Use suitable thread-lock where appropriate and inspect driveshaft coupling points for wear before final assembly.

Tuning and maintenance: this axle is intended as a drop-in replacement to restore chassis geometry or to replace a worn rear end. For setup and tuning, check axle alignment under load, verify driveshaft pinion engagement, and re-check wheel hex fastness after initial runs. Periodic inspection of bearings and fasteners will help maintain predictable handling on scale trails.