Axial Racing SCX10 Alloy Hex Adapter 12mmx6mm SCX010 by GPM  [SCX010]

Hex Adapter for Axial SCX10

This 4pcs set of alloy hex adapters is made for use with Axial Racing SCX10 scale crawlers and compatible wheel hubs that accept a 12mmx6mm hex interface. The pack contains four matched adapters that sit between wheel and hub to preserve a consistent hex interface when swapping wheels or fitting aftermarket rims.

The part is a simple, low-profile replacement with a neutral finish intended for scale RC use only. Before you fit these adapters confirm your hub and wheel hex measures 12mmx6mm to ensure correct fit. Installation uses the vehicle's existing hardware, so keep factory screws and hardware unless a wheel supplier specifies replacements.

For setup and tuning these adapters help keep wheels concentric and can reduce play at the wheel interface when used with correctly sized wheels and hub hardware. Keep mating surfaces clean and recheck fastener torque as part of routine maintenance and after your first run.