Axial Racing AX10 Deadbolt Rear Axle Lock-out Aluminum Upgrade - AX10-24008-OR by Jazrider  [AX10-24008-OR]

Reinforced rear axle lock-out for AX10 Deadbolt

This RC-scale aluminum rear axle lock-out is designed specifically for Axial Racing AX10 Deadbolt chassis and is finished in orange. It serves as a direct replacement or hop-up that stiffens the rear axle area to reduce unwanted flex and help maintain axle alignment under load; the unit is a chassis-level part for scale rock crawlers and trail rigs and is identified as AX10-24008-OR.

Installation notes: the part replaces the stock rear axle lock-out on AX10 Deadbolt layouts using the same mounting holes and hardware pattern. Basic hand tools such as a hex driver and appropriate sockets are sufficient for fitting, and a torque check after the initial runs is recommended to confirm fastener security and alignment.

Tuning role: fit this lock-out when you need a firmer rear axle response for low-speed crawling or when installing heavier drivetrains. It helps keep drivetrain components indexed during slow, high-torque maneuvers and is useful when adjusting suspension or wheel offset for obstacle clearance.