Axial Racing AX10 Deadbolt Aluminum Motor Plate with Heat Sink - AX10-24015-OR by Jazrider  [AX10-24015-OR]

AX10 Deadbolt Aluminum Motor Mount with Integrated Fins

This aluminum motor plate features an integrated heat sink designed specifically for the Axial Racing AX10 Deadbolt platform and carries the model number AX10-24015-OR. Finished in orange, the part offers a rigid motor mounting surface with passive fins to help draw heat away from the motor area during technical trail and crawler runs.

Fitment targets the AX10 Deadbolt chassis layout. The plate aligns with the standard AX10 Deadbolt motor bolt pattern and mounting points; verify your chassis uses the same bolt locations before fitting. This is an aftermarket hop-up for motor mounting and thermal assistance on scale electric rigs, not intended for full-size vehicles.

Installation is a simple swap: remove the motor while keeping wiring clear, mount the replacement plate to the chassis points, confirm motor-to-spur alignment, then refit and secure the motor ensuring straight pinion-to-spur engagement. The heatsink acts passively, so maintain good airflow and avoid blocking the fins when routing battery, ESC, or cables.

Use this plate to stabilise the motor position and gain modest passive cooling at the mount interface. It works best with correct gear mesh, a ventilated layout, and motors and ESCs matched to your setup; treat it as supplemental heat management rather than an active cooling system.