Axial AXI03007 SCX10 III Center Gearbox Case and Mount SCX3038BA by GPM  [SCX3038BA]

Center gearbox case and mount kit

This aluminium center gearbox case and mount set is built for scale RC use on Axial SCX10 III platforms to shield the center transmission and stabilise nearby components. The assembly is a 23pcs aftermarket replacement identified as SCX3038BA and intended for RC use only.

The main body is machined from 6061-T6 aluminium to balance low mass with tensile strength, and features a 3D hollowed profile that trims weight while increasing surface area to assist heat dissipation from adjacent driveline parts. Multiple threaded holes and mounting points allow flexible drive orientations and suspension link routing without chassis modification.

Installation notes: use the supplied stainless steel screws and confirm alignment before final torque to prevent cross-threading. The set includes round and flat head stainless screws in assorted lengths that match factory mounting locations on compatible Axial SCX10 III variants. As with any aftermarket aluminium component, tighten progressively and avoid over-torquing into plastic bosses.

Tuning effects: fitting this case increases mechanical protection for the centre gearbox and adds lateral stiffness between the center section and suspension pick-ups, which can change chassis feedback on technical trails. Treat it as a durability and consistency upgrade rather than a power performance part.

For builders wanting a lightweight aluminium option to protect the center transmission and firm up chassis link stability on SCX10 III rigs, this SCX3038BA set supplies the mounting points and hardware for a direct aftermarket replacement.