Axial AX10 Deadbolt Front Offset Axle Link Mount - AX10-24013-OR by Jazrider  [AX10-24013-OR]

Offset Front Link Mount Overview

This is a scale RC front offset axle link mount designed for the Axial AX10 Deadbolt platform, model AX10-24013-OR. The component shifts the front link connection point outward from the axle centreline to change steering and suspension response while remaining straightforward to fit on standard AX10 Deadbolt setups.

Made from aluminium, the mount increases stiffness at the link pickup compared with common stock plastic pieces, helping to retain link geometry under load and during low speed technical moves. It serves as an aftermarket upgrade for RC rock crawling and off road tuning where consistent axle behaviour is important.

Installation notes: the part replaces the stock front link mount and uses the existing fastener locations on the AX10 Deadbolt axle housing. After fitting, check link angles and wheel clearance through full suspension travel and alter link lengths or pivot spacing as required to reach the desired roll centre and steering feel. Recheck fastener torque after the initial runs.