Axial SCX6 1/6 Aluminum Steering Knuckle Carriers C-Hubs - JR-SCX602-TI by Jazrider  [JR-SCX602-TI]

Aluminum steering knuckle carriers for SCX6

This aluminum steering knuckle carrier and C-hub set is made for 1/6 scale Axial SCX6 Jeep models and supplied by JAZRIDER as JR-SCX602-TI. The components serve as a direct upgrade or replacement for plastic parts when drivers want metal steering pieces that match chassis durability and support finer tuning for trail and rock crawling.

The package targets the steering pivot points: C-hubs mount on the axle housing while the knuckle carriers position the knuckles and wheel hex. Swapping plastic for aluminum alters wear behavior and gives a firmer response under load, helping with toe, caster, and steering link geometry adjustments on a tuned SCX6 rig.

Installation notes: use the vehicle's existing hardware and follow chassis service procedures, confirm thread engagement on all hex screws, and check clearances with suspension and wheel hubs before final torque. If you reuse bearings or seals, verify they seat squarely in the aluminum bores to prevent binding.

For builders upgrading a scale SCX6 crawler, this aluminum knuckle and C-hub set offers a straightforward route to firmer steering linkage and easier geometry tweaks; always confirm wheel hex and bearing stack compatibility before finishing installation.