JAZRIDER JR-SCX607-BK 7075 Aluminum Steering Arm for Axial 1/6 SCX6 Jeep - Black  [JR-SCX607-BK]

Axial 1/6 SCX6 Jeep 7075 Aluminum Steering Servo Arm (Black)
Price:
CAD$9.50
Brand:
JAZRIDER
Model:
JR-SCX607-BK
Condition:
Brand New
Available in warehouse
Write a review

Refine Steering on Your Axial SCX6 Jeep

The JAZRIDER 7075 Aluminum Steering Servo Arm JR-SCX607-BK is a practical upgrade for Axial 1/6 SCX6 Jeep JLU Wrangler 4WD owners. The black anodized finish helps resist wear while the machined aluminum body tightens steering feel for better response on trail runs and pavement.

Built Tough, Fits Right

Made from high-grade 7075 aluminum, this servo arm gives strength without excessive weight. It is intended to fit the Axial SCX6 Jeep JLU Wrangler and installs using standard servo link hardware for a straightforward swap.

Sharper Control for Technical Driving

Installing the JAZRIDER aluminium arm reduces play in the steering linkages and improves precision during tight manoeuvres. This is a good upgrade for hobbyists who focus on handling consistency and reliable steering feedback.

Will this servo arm work on other Axial models?

This arm is designed for the Axial SCX6 Jeep JLU Wrangler 4WD. It may fit other models with the same spline and mounting pattern, but you should verify spline size and screw positions before fitting.

Any tips for installing the JR-SCX607-BK?

Remove the stock plastic arm, align the splines carefully, and tighten mounting hardware evenly. Use a small amount of threadlocker on metal-to-metal screws if you run on rough terrain.

How should I maintain the aluminium arm?

Check screws after a few runs, clean grit from the mounting area, and inspect the anodized surface for burrs. Replace if you notice deformation from heavy impacts.

Copyright © 2008-2025 rcjaz.ca All rights reserved