AX10 Scorpion Graphite Servo Mount Plate AX10-19/WO by 3Racing  [AX10-19/WO]

AXIAL AX10 Scorpion Chassis Graphite Servo Plate - 3RACING AX10-19/WO
Price:
CAD$10.54
Brand:
3Racing
Model:
AX10-19/WO
Condition:
Brand New
Write a review

Graphite Servo Plate Upgrade

This lightweight graphite servo plate is an aftermarket upgrade sized for use with the AXIAL AX10 Scorpion chassis. It creates a stiffer mounting area for the servo to minimise local flex and help maintain consistent steering feedback on technical crawls and tight trail sections.

Fitting is intended for experienced model builders: move your existing servo into the graphite plate using the AX10 Scorpion servo footprint and reuse original mounting hardware where practical. The plate provides a firmer anchor so steering commands face less chassis-induced compliance.

Choose this plate when you want a simple, low-mass change to improve chassis rigidity around the servo bay without swapping servo types or altering the drivetrain layout.

Will this fit the stock AX10 Scorpion servo location?

Yes, the plate uses the stock AX10 Scorpion servo footprint; verify alignment before final tightening and use original screws where possible.

Do I need to change my servo after installing it?

No, the plate is intended to work with your current servo. It improves the mounting stiffness rather than altering servo specifications.

What handling difference should I expect?

You should notice reduced local flex at the servo bay and slightly firmer steering feedback during slow, precise manoeuvres; overall effect depends on your full setup.

Copyright © 2008-2026 rcjaz.ca All rights reserved