AX10 Scorpion Adjustable Turnbuckle M6x55 Threaded Link AX10-21/GR by 3Racing  [AX10-21/GR]

AXIAL AX10 Scorpion Chassis Turnbuckle M6x55 - 3RACING AX10-21/GR
Price:
CAD$17.57
Brand:
3Racing
Model:
AX10-21/GR
Condition:
Brand New
Write a review

Precision Turnbuckle for AX10 Scorpion

This M6x55 RC turnbuckle fits the AX10 Scorpion chassis and is listed as part AX10-21/GR. It is a threaded M6x55 rod intended to replace or tune steering and suspension link lengths on scale crawlers built on the AX10 Scorpion platform.

The turnbuckle allows incremental linkage adjustment to correct toe, caster and ride-height relationships without changing other chassis parts. Fit it where a straight threaded link is required to set geometry or to swap in for a bent or worn link; always confirm thread size and effective length before fitting to ensure correct engagement with your rod ends or ball studs.

Installation notes: thread the M6x55 rod into the matching rod ends or ball studs until seated, match adjustments on both sides, and verify alignment under static load before running. Make small changes and recheck thread engagement to preserve safe steering and suspension operation.

Will an M6x55 turnbuckle fit my AX10 Scorpion ball studs?

Check that your ball studs or rod ends use M6 threads and that 55mm overall length clears suspension travel. Measure existing link length before swapping to confirm fitment.

Can I use this for both steering and suspension links?

Yes, the M6x55 turnbuckle is suitable for either steering or suspension link duties where a threaded straight rod is required. Adjust gradually and keep symmetry side to side.

Any setup tips before the first run?

Set both sides to the same length, check toe and caster visually, tighten lock nuts if used, and perform a static alignment check before crawling to avoid binding or uneven wear.

Copyright © 2008-2026 rcjaz.ca All rights reserved