Auper D6 Upper Deck Mount, Anodized Red - SAK-D6808E/RE by 3Racing  [SAK-D6808E/RE]

Reinforced upper deck for Auper D6

The SAK-D6808E/RE is an anodized red aluminum upper deck mount designed to fit the Auper D6 chassis. As an RC-scale component, it supplies a stable, repeatable mounting point that influences chassis stiffness and the way loads transfer between the front and rear sections.

Installation is straightforward for experienced builders: confirm alignment with the Auper D6 mounting points, check clearances near the radio tray and battery area, and tighten fasteners progressively to avoid distortion. Retain kit fasteners where suitable or use the hardware specified by your kit to ensure correct fit.

From a setup perspective, swapping the upper deck mount alters local rigidity in the main chassis plate. Use this part to refine roll feel, control chassis twist under power, or to introduce a firmer center section for particular track surfaces. Make incremental changes and evaluate with short test runs to judge handling differences.

Maintenance is simple: keep mounting faces free of debris, inspect for wear or bending after heavy use, and avoid abrasive cleaners that could damage the anodized finish. Confirm compatibility with your Auper D6 build and do not imply use on full-size vehicles.