Auper D6 Rear Upright - SAK-D6816/PU (Purple) by 3Racing  [SAK-D6816/PU]

Rear hub upright for Auper D6

This aluminum rear upright is a direct replacement intended for use on the Auper D6 RC chassis. It supports the rear wheel hub and links to the suspension carrier, retaining factory mounting locations while offering a metal replacement for stock composite parts.

Targeted at hobbyists who service or tune Auper D6 touring cars, the upright maintains consistent rear suspension geometry. Fit it when repairing a damaged piece or when you need the dimensional stability of metal in hub areas that influence toe and camber response.

Installation follows the same basic steps as the original part: remove the wheel and hub assembly, detach the old upright from the hub carrier and suspension links, fit the replacement upright, and reassemble while checking bearing fit and alignment. No special tools beyond common RC maintenance tools are required; verify screw torque and clearances before running.

As an aluminum replacement for the Auper D6 rear upright, this part helps restore or stabilise rear hub geometry during maintenance and tuning tasks.