Auper D6 Rear Bulkhead Belt Upgrade - Aluminum Red - SAK-D6808A/RE by 3Racing  [SAK-D6808A/RE]

Rigid Aluminum Rear Bulkhead Belt for Auper D6

This aluminum rear bulkhead belt is specified as a replacement or hop-up for the Auper D6 chassis, providing a direct swap where the OEM rear bulkhead belt is used. The component is identified by model SAK-D6808A/RE and is finished in red to match visual upgrades on the same platform.

Installation is straightforward for technicians familiar with Auper D6 assemblies: remove the original rear bulkhead belt, confirm alignment with the rear belt routing path, and secure with the existing fasteners. Verify belt tension and run the drivetrain slowly at first to ensure the belt sits cleanly without interference.

In tuning terms this part serves a structural and routing role—aluminum material adds rigidity compared with some stock plastic pieces, helping keep belt alignment stable under load and supporting consistent rear-end behavior during setup changes.

Use this SAK-D6808A/RE unit when replacing a worn rear bulkhead belt on an Auper D6 or when adding a lightweight aluminum option for improved belt stability and consistent rear-end response.