Auper D6 Rear Bulkhead Belt Plate SAK-D6808A/BU Upgrade by 3Racing  [SAK-D6808A/BU]

Rear bulkhead belt plate for Auper D6 chassis

This machined aluminum rear bulkhead belt is a scale replacement designed to fit the Auper D6 chassis. The component locates at the rear bulkhead to control belt routing and provides a rigid mounting surface where the belt crosses the bulkhead, preserving alignment under load.

Compatibility is centred on Auper D6 layouts that use a rear bulkhead belt path. The part is supplied in a blue finish and is intended as a direct-fit hop-up on kits where the original belt plate is removable or serviceable.

Installation normally follows the kit's rear bulkhead access procedure and uses the existing mounting interfaces; consult your Auper D6 manual for fastener locations and torque guidance. As a tuning item, the aluminum belt plate reduces flex at the belt pass and can contribute to more consistent drivetrain response during heavy cornering and acceleration.

Use this machined aluminum rear bulkhead belt to replace or upgrade the stock rear belt pass on Auper D6 kits when increased rigidity and repeatable belt alignment are required for precise setup tuning.