Auper D6 Rear Body Post Upgrade SAK-D6820/PU Purple by 3Racing  [SAK-D6820/PU]

Lightweight aluminum rear post

This component is an RC-scale aluminum rear body post intended for use with the Auper D6 platform and sold under model SAK-D6820/PU. It functions as a direct replacement or an upgrade to the rear body mounting point, keeping the shell secured during handling and setup without altering the body geometry.

Fitment is specific to Auper D6 body mounts as stated, so confirm your chassis uses the same rear post location before fitting. The part comes in a purple finish for visual customisation while still serving as a robust mounting element.

Installation is straightforward: remove the factory rear post, line up the replacement with the factory body post hole, and fasten with the original hardware or compatible body clips; only common hobby hex drivers and pliers are required. Recheck body alignment after install and trim the shell where necessary to restore clip clearance.

During setup the rear body post provides a consistent reference for shell placement and offers a firm anchor for rear body clips when checking ride height or sway. Treat it as a setup and mounting component rather than a primary performance tuning part.