Auper D6 Motor Mount Base A Aluminum SAK-D6808F/BU by 3Racing  [SAK-D6808F/BU]

3RACING Auper D6 Aluminum Motor Mount Base A Blue - SAK-D6808F/BU
Price:
CAD$7.87
Brand:
3Racing
Model:
SAK-D6808F/BU
Condition:
Brand New
Write a review

Motor Mount Base A - Aluminum Precision for Auper D6

This aluminum motor mount base fits the Auper D6 1/10 electric on-road chassis and secures the motor while allowing fine fore-aft and rotational adjustments to achieve correct pinion-to-spur engagement and drivetrain alignment.

Installation notes: the part locates to the Auper D6 motor block and uses the chassis fastener points; align the motor shaft with the spur centreline and verify pinion mesh before final tightening to prevent premature wear to gears or bearings.

Tuning role: the machined aluminum base gives a firm reference for repeated setup changes, helping preserve consistent mesh and torque transfer when swapping motors, pinions, or adjusting gear ratios during track tuning sessions.

How can I confirm this mount matches my Auper D6?

Check that your chassis uses the same motor block hole pattern as the Auper D6; the part is produced for that platform so confirm mounting points align before fitting.

Will using aluminum alter driveline feel?

An aluminum base increases mounting rigidity and repeatability, which can stabilise mesh and drivetrain behaviour, but it does not change the motor's power output on its own.

What should I check before final torquing?

Verify motor alignment to the spur centreline, confirm pinion mesh across the rotation range, and tighten mount fasteners evenly to avoid any shift under load.

Copyright © 2008-2026 rcjaz.ca All rights reserved