Auper D6 Belt Drivetrain Shaft, Red Anodized SAK-D6809/RE by 3Racing  [SAK-D6809/RE]

Belt-Drive Replacement Shaft

Designed as a direct replacement for belt-driven Auper D6 kits, this machined aluminum shaft features a red anodized finish to resist wear while remaining serviceable for routine drivetrain work. It is sized to match the original shaft geometry used in Auper D6 belt-driven transmissions.

During installation the shaft locates through the chassis mounts and engages pulleys and the belt; check belt alignment, pulley seating, and set screw engagement at fitment. This component is intended to support routine setup and on-track adjustments when assembled correctly and does not imply added power beyond proper assembly and alignment.

Use this shaft when replacing worn drivetrain hardware or when assembling an Auper D6 kit to ensure correct belt routing and reliable mechanical fit; inspect mating components and bearings when installing.