Auper D6 Aluminum ARS Linkage Mount SAK-D6808D/RE by 3Racing  [SAK-D6808D/RE]

Auper D6 Aluminum ARS Linkage Mount

This machined aluminum ARS linkage mount replaces the plastic bracket on Auper D6 1/10 touring chassis and reuses the chassis' existing linkage locations. It features a red anodized face that provides a precision mounting surface to take the place of the stock plastic component.

In service, the mount supplies alternate ARS mounting points so you can fine tune linkage geometry and roll response without replacing major suspension parts. Moving to an aluminum unit gives a firmer reference for link connections, helping alignment hold under load and making setup changes more repeatable during tuning sessions.

Fitting is straightforward: remove the original mount, position the aluminum piece in the same holes, and fasten it with the kit's existing hardware. After fitment, check link lengths and ball-end alignment at full droop and full bump to ensure there is no binding or unintended preload.

Use notes: this is a scale spare intended for chassis setup and handling adjustments; it suits hobbyists refining linkage settings on 1/10 touring car builds that use the Auper D6 mounting pattern.