Arrowmax AM-364033 64P 33T 7075 Hard-Anodized Pinion Gear  [AM-364033]

Arrowmax AM-364033 Pinion Gear 64P 33T 7075 Hard
Price:
CAD$7.30
Brand:
Arrowmax
Model:
AM-364033
Condition:
Brand New
Write a review

7075 Hard-Anodized Pinion Built for Reliability

The Arrowmax AM-364033 pinion is machined from high-grade 7075 aluminum with a hard anodized finish, offering a 64-pitch 33-tooth design that stands up to regular use. It is produced to resist wear while keeping weight low for improved drivetrain response.

Consistent Drive Across Road Surfaces

This pinion provides stable gear engagement whether you are running on smooth asphalt or rougher off-road tracks. Its light but strong construction reduces wear and helps maintain consistent power transfer during spirited driving or competition.

Fits Standard 64P Spur Gears

The 64P 33T layout integrates easily with common spur gears, making it a flexible upgrade for a wide selection of RC cars. It supports efficient torque transfer without adding unnecessary complexity to your drivetrain.

Is this pinion suitable for high-speed runs?

Yes. The 7075 aluminum and hard anodized surface handle higher RPMs well, but always check gear mesh and motor load for your specific setup.

Will it work with different brand spurs?

Generally yes. The standard 64P pitch matches many spur gears across brands, though you should confirm tooth count and bore compatibility before fitting.

Any tips for installation?

Set correct gear mesh using shims or a gauge, tighten the set screw with a threadlocker if needed, and recheck mesh after a short run-in to avoid premature wear.

Copyright © 2008-2026 rcjaz.ca All rights reserved