ARRMA Mini Kraton 3S CVD Drive Shafts 71mm MAKM071F/RS by GPM  [MAKM071F/RS]

Installation-ready 71mm CVD shafts for Mini Kraton 3S

The MAKM071F/RS front and rear CVD drive shafts are aftermarket replacements designed for ARRMA Mini Kraton 3S models. Machined from 4140 steel with a blackened hardening finish, these 71mm shafts are specified at 71mm from pin center to pin center and intended as direct replacements for part ARA-2668. They are offered as RC-scale drivetrain components for the 1/16 Mini Kraton platform and built to resist wear in typical hobby use.

Installation is straightforward when fitting into the Mini Kraton 3S front or rear CVD assemblies that use the original ARA-2668 shafts. During fitment check retaining pins and e-clips for correct seating and confirm the shaft length matches the 71mm center-to-center measurement before final assembly. As a tuning item, upgraded steel CVD shafts help maintain drivetrain alignment under load and reduce the risk of accelerated wear compared with softer stock components.

These shafts provide a direct material upgrade for Mini Kraton 3S owners seeking a durable replacement for factory CVDs while preserving stock fitment and geometry.