ARC A11 Rear Lower Suspension Arm Replacement - O-ARCP11R by Factory Pro  [FP-O-ARCP11R]

Rear lower arm for ARC A11 chassis (single unit)

This single rear lower suspension arm is designed for 1/10-scale RC touring cars and is supplied as 1pc under Factory Pro O-ARCP11R. It is made for use with the ARC A11 chassis as a direct replacement to restore rear suspension geometry or to support setup changes.

Fit this arm when repairing a damaged link, checking geometry, or swapping parts to alter handling. The arm locates the rear hub relative to the chassis and influences toe, camber under load, and roll center behavior; factor these setup changes into your tuning decisions.

Installation tips: confirm correct orientation and mounting points before final tightening, inspect adjacent ball studs and hardware for wear, and recheck wheel alignment after fitting. The item is supplied as a single 1pc unit; verify fit with your ARC A11 layout prior to installation.