APC AP1004 10x4 Propeller for RC Model Aircraft  [AP1004]

APC PROPELLER 10x4
Price:
CAD$6.30
Brand:
APC
Model:
AP1004
Condition:
Brand New
Write a review

Fit and function overview

This APC AP1004 PROPELLER 10x4 is an RC-scale propeller intended for model aircraft use, sized 10x4 to suit common mounting and performance ranges for small to medium electric setups.

The description concentrates on practical fit, safe installation tips, and how blade choice influences thrust and motor loading rather than making promotional claims. Use standard prop mounting hardware and confirm shaft diameter and spinner clearance before flight.

Installation notes: balance the propeller on a prop balancer, secure it to the motor shaft with the correct nut or adapter for your setup, and check for sufficient clearance from the fuselage or cowling to avoid contact at full pitch.

Tuning role: a 10x4 prop provides stronger static thrust than higher-pitch alternatives while keeping motor current moderate on suitably matched motors and ESCs; change props gradually when trimming peak RPM or climb performance.

How should I mount the prop to my motor shaft?

Start by confirming your motor shaft size and select the correct adapter or collet. Many small RC setups use 3mm or 5mm shafts with matching hubs or adapters to secure the prop.

Is balancing necessary before first flight?

Yes. Balancing removes vibration that can accelerate bearing wear and destabilize the airframe. Use a prop balancer and remove small high spots until the blade sits level.

What should I check for motor and ESC compatibility?

On first runs monitor current draw and motor temperature. Ensure your ESC and motor continuous ratings exceed observed loads and be prepared to select a different battery or prop if currents are too high.

Copyright © 2008-2026 rcjaz.ca All rights reserved