AM Honeycomb Chassis Battery Holder Mount - Arrowmax AM-950043  [AM-950043]

Secure battery mounting for AM Honeycomb Chassis

The Arrowmax AM-950043 battery holder set is an aftermarket accessory built to hold battery packs on the AM Honeycomb Chassis. Below is a concise, technical overview that covers fitment checks, installation steps, and how the holder affects chassis balance and tuning.

The holder is made specifically for the AM Honeycomb Chassis layout, so confirm tray dimensions and mounting hole patterns before fitting. Typical checks include verifying screw hole alignment with chassis bosses, ensuring the battery sits flush on the tray, and checking clearance for leads and connectors to prevent interference with the ESC or servo.

Installation follows common chassis practices: place the holder on the designated battery area, align mounting holes, then tighten screws gradually to keep even pressure. Use the chassis mounting points provided; if small adjustments are needed, re-centre the pack and only apply final torque after confirming fit. The component acts as a mounting interface and will affect how the battery sits relative to the chassis.

Small shifts in battery location will change the centre of gravity and can alter handling. Use the Arrowmax holder to fine-tune fore-aft positioning and lateral centring during setup. When you change battery size or chemistry, re-check fit and secure mounting to avoid movement under load.

The Arrowmax AM-950043 battery holder set provides a reliable mounting interface for the AM Honeycomb Chassis to stabilise battery placement and assist setup work; always confirm fitment before final installation.