60HNS Exhaust Pipe Clamp Hatroi HA140  [HA140]

Clamp for 60HNS Exhaust

This Hatroi HA140 pipe clamp is an RC-scale replacement part made to work with 60HNS mufflers. It functions as an inline mounting clamp to keep exhaust pipe sections aligned and to reduce unwanted movement during running and while making setup adjustments.

Intended role: the clamp acts as a simple mechanical anchor on the exhaust pipe to preserve outlet alignment, support repeatable tuning changes, and hold connections steady when swapping or adjusting muffler components. It is a support item for model exhaust assemblies rather than a performance tuning part.

Installation notes: place the clamp around the exhaust pipe section that mates to the 60HNS muffler, set the pipe angle you require, and tighten until the pipe stays put under normal handling. Verify fit before final tightening and recheck after first runs. Avoid overtightening, which can deform the tube.

Maintenance: check the clamp regularly for corrosion or loose fasteners after running sessions, and confirm it keeps a snug fit to prevent exhaust leaks at the joint. Replace the clamp if it shows fatigue or damage.