3Racing Zero Cero Lower Suspension Arm Set O-3CP016 by 3Racing  [FP-O-3CP016]

Lower arm function and fit

This FP-O-3CP016 lower suspension arm set is an aftermarket replacement intended for the Zero Cero 1/10-scale kit. It fits the factory mounting layout and is supplied to refresh worn components or to support routine maintenance and setup changes.

The matched pair replaces damaged or tired links between the hub carrier and chassis, affecting camber, toe and roll center when used with shocks and link adjustments. Inspect hinge-pin alignment and related hardware before fitting to avoid binding and to maintain predictable handling.

Installation notes: remove wheel and hub carrier to access the lower arm pins, transfer bearings or bushings from the old arms if needed, and refit using the original hinge pins and retainers. After installation, check free movement through full travel and re-verify alignment before use.

For Zero Cero owners who need a straightforward replacement arm set for upkeep or a chassis refresh, this unit supplies the expected form and mount points for standard suspension setups; always confirm component condition and alignment after fitting for consistent handling.