3Racing Tamiya FF-03 Front Upper Linkage Mount FF03-06/LB - RC Spare Part  [FF03-06/LB]

Front upper link mount for FF-03 setup

This is an RC-scale front upper linkage mount made for the Tamiya FF-03 chassis, supplied as the FF03-06/LB replacement. It acts as the anchor point for the front upper link that defines suspension geometry and helps keep arm position consistent during setup and on-track running.

Fitment and role: intended for vehicles with the FF-03 layout, the mount locates the front upper link against the bulkhead and suspension arms and contributes to controlling camber and caster changes under load. Replace worn mounts or use this part when restoring factory suspension geometry after upgrades.

Installation notes: check alignment before final torque, use the correct hex screw sizes for your chassis, and confirm pivot clearance after fitting. If you alter link length or pivot spacing while tuning, inspect the mount for interference with suspension travel and steering linkages.

Tuning guidance: small upper link position changes shift the front roll centre and transient response, so make incremental adjustments and test on the same surface to isolate effects. Keep fasteners secure and recheck mounting points after a few runs.