3Racing TAMIYA F103RM Friction Damper Pole F103RM-13 - RC Spare Part  [F103RM-13]

Friction damper pole for F103RM setups

This F103RM-13 friction damper pole is an RC replacement part for the TAMIYA F103RM chassis. It is intended as a direct swap for the internal damper pole used in friction-style dampers to help dial in precise damping feel on 1/10 touring cars.

Fitting is simple for anyone familiar with the F103RM damper unit: remove the existing pole, inspect the damper internals for wear or debris, then install the F103RM-13 pole using the original retainers and screws. Standard hex drivers are normally all that is required.

In practical tuning the pole sits inside the friction assembly and changes how damping forces transfer, so small adjustments to the pole or damper reassembly give finer control over rebound and compression feel rather than large handling shifts.

Service notes: keep the pole and bore free of grit, check for any side play or scoring, and replace the pole if wear causes rough motion. Regular checks preserve consistent damping lap after lap.