3Racing MIF-026/TI Kyosho Mini Inferno / Mini Inferno ST 1 Degree Rear Suspension Holder  [MIF-026/TI]

Compact rear holder summary

This MIF-026/TI rear suspension holder is a compact replacement tailored for Kyosho Mini Inferno and Mini Inferno ST chassis, offering a 1 degree rear block to adjust toe bias. The piece is supplied in a titanium colour finish and is intended for measured setup changes rather than heavy structural upgrades.

The holder's function is simple: it shifts rear suspension geometry slightly to influence rear toe, letting drivers refine corner entry and mid-corner balance on carpet or asphalt micro on-road surfaces. It fits the Mini Inferno stock mounting points and serves as a direct-replacement suspension holder rather than a multi-function upgrade component.

Fitting is a basic swap of the existing rear holder: remove the rear linkage hardware, replace the stock holder with the MIF-026/TI using the factory fasteners and verify thread engagement, then check alignment and wheel tracking before running. After a few laps recheck ride height and toe and make incremental adjustments rather than large jumps.

Tuning notes: a 1 degree rear offset creates subtle changes; expect modest shifts in rear bite and rotation instead of dramatic handling moves. Use this holder when you need small toe correction to reduce understeer or to sharpen rear rotation while keeping the overall chassis behaviour predictable.