3Racing Magnum 4.5T BMTC-M045S/BL Brushless Sensored Motor  [BMTC-M045S/BL]

Magnum 4.5T Brushless Sensored Motor - BMTC-M045S/BL
Price:
CAD$100.33
Brand:
3Racing
Model:
BMTC-M045S/BL
Condition:
Brand New
Write a review

Track-ready power from the 3Racing Magnum 4.5T

Club racers and weekend competitors will appreciate the controllable power and consistent output of the 3Racing Magnum 4.5T Brushless Sensored Motor BMTC-M045S/BL. Built to handle the demands of circuit racing, this unit balances acceleration and top speed while keeping throttle inputs predictable.

Precision sensored design

The Magnum series uses a sensored configuration to deliver smooth starts and accurate throttle modulation. That sensored feedback reduces cogging at low rpm and improves consistency when paired with a quality ESC, making it easier to nail tight turn exits.

Suited to competitive driving

With a 4.5T wind and brushless construction, the motor provides race-oriented rpm and longevity compared with brushed alternatives. It is especially practical for 1/10 scale racers who need repeatable lap times and minimal maintenance between events.

Tuning advice for best results

To get the most from the Magnum 4.5T, match it with an ESC rated for sustained high current and use programmable profiles to refine throttle curves and braking. Small adjustments to gearing and punch control will help adapt the motor to track layout and surface grip.

Specifications

  • Type: Brushless Sensored Motor
  • Turns: 4.5T
  • Compatibility: 1/10 Scale RC Cars
  • Design: Sensored for Precision Control

The 3Racing Magnum 4.5T BMTC-M045S/BL is a reliable upgrade for racers wanting cleaner throttle response and usable power across a variety of tracks. Its brushless sensored layout reduces on-track variability and keeps maintenance low.

It will run on many ESCs, but for consistent performance you want an ESC that supports sensored motor timing and can handle high amp peaks commonly seen in race setups.
Lower gearing helps with acceleration out of corners on technical tracks; experiment with one or two tooth changes on the spur gear while monitoring temps and amp draw.
Sensor wires add a small wiring step but are straightforward if your ESC supports sensored inputs. Secure the wires away from moving parts and route them cleanly for best results.
Inspect bearings and mounting hardware periodically and check temperature after runs. Regular visual checks and avoiding overheating will extend service life.

Copyright © 2008-2026 rcjaz.ca All rights reserved