3Racing FW05-RR005-GT Kyosho FW05RR Woven Graphite Front Shock Tower  [FW05-RR005-GT]

Kyosho FW05RR Front Woven Graphite Shock Tower - 3RACING FW05-RR005-GT
Price:
CAD$10.54
Brand:
3Racing
Model:
FW05-RR005-GT
Condition:
Brand New
Write a review

Woven graphite front shock tower

This front woven graphite shock tower is made for RC application and carries the designation FW05-RR005-GT, marked for Kyosho FW05RR fitment. The component replaces the stock tower to increase stiffness at the front shock mounting area while keeping mass low thanks to woven graphite material.

On-track the tower is used as a tuning item for the front suspension, supplying a firmer mounting platform that alters bump response and roll behaviour. That change helps when fine tuning spring and damper settings or shifting anti-roll balance during setup sessions.

Fitting is straightforward on compatible chassis: remove the original tower, move over the shock mounts and any retained hardware, then secure the new tower at the factory mounting points. Always check clearances and hole alignment to ensure compatibility with the Kyosho FW05RR mounting pattern before running.

How can I confirm this matches my FW05RR tower holes?

Measure the front shock tower mounting holes on your chassis and compare them to the replacement; the part is listed for Kyosho FW05RR so matching the hole pattern confirms fitment.

What handling change should I expect after fitting?

Expect a stiffer front end that sharpens steering feedback and reduces flex under load, which can make spring and damper adjustments more predictable.

Do I reuse the original hardware when installing?

Yes, transfer the existing shock mounts and any original screws or spacers and secure the replacement using the chassis mounting points, checking alignment and clearance first.

Copyright © 2008-2026 rcjaz.ca All rights reserved