3RACING 3RAC-3PY/21 Aluminum Center Pulley Gear - Centre Drive Upgrade  [3RAC-3PY/21]

3RACING Aluminum Center Pulley Gear T21 - 3RAC-3PY/21
Price:
CAD$10.47
Brand:
3Racing
Model:
3RAC-3PY/21
Condition:
Brand New
Write a review

Improve RC drivetrain performance with 3RACING 3RAC-3PY/21

The 3RACING Aluminum Center Pulley Gear T21, model number 3RAC-3PY/21, is made to strengthen your RC vehicle's drive system while keeping rotating mass low. Machined aluminum construction gives a useful balance of rigidity and light weight, making it a smart swap for hobbyists after longer component life on the track.

Why pick an aluminum pulley for your setup?

Aluminum offers a notable mix of durability and low weight that helps preserve top-end speed and drivetrain efficiency. Compared with stock plastic pulleys, the metal unit stands up better to repeated high-load runs and abrasive surfaces, helping cut down on replacement frequency.

Compatibility notes and simple fitment

This pulley suits a wide variety of 1/10 scale RC cars and can be installed with standard hand tools. Check gear alignment and belt or shaft interfaces during installation to ensure smooth operation without extra modifications.

Will this pulley handle repeated high speed runs?

Yes. The aluminium construction resists deformation under sustained high-speed use better than typical plastic pulleys, improving longevity for frequent track sessions.

Do I need special tools to fit the 3RAC-3PY/21?

No special tools are required. Basic metric hex keys and a driver are usually enough, but verify set screws and torque to your model's specs.

Will this work with belt or shaft drive setups?

It is primarily intended for compatible center pulley arrangements on many 1/10 scale cars; confirm spline and bore dimensions against your chassis before purchase.

Copyright © 2008-2025 rcjaz.ca All rights reserved