35cc Muffler Pipe Clamp D=60mm - Hatroi HA151  [HA151]

Secure 60mm Exhaust Clamp

This Hatroi HA151 pipe clamp is an RC-scale accessory designed to fasten 60mm exhaust pipes to 35cc nitro mufflers. It suits small nitro-powered models and is focused on holding the pipe joint steady while allowing fine alignment during setup and tuning.

The clamp fits standard 35cc RC muffler brackets where a 60mm pipe diameter is required. For installation, slide the clamp over the joint, align the muffler and header, then tighten the bolts evenly and gradually to avoid distorting the pipe flange. Verify fit and clearance around body mounts and adjacent parts before fully tightening.

When tuning and maintaining the engine, a correctly fitted clamp helps preserve the exhaust seal and consistent back pressure, supporting repeatable engine response. Periodically inspect the clamp for any deformation and ensure fasteners are torqued evenly to prevent leaks or misalignment.