1/8 Off-Road Strike Wing for Buggies and Truggies - HUDY 293580-Y  [HSP-293580-Y]

Compact 1/8 Off-Road Wing

The HUDY 293580-Y Strike Wing is an RC-scale 1/8 off-road wing designed to balance stability and low weight for race-focused setups.

Its ultra-low profile and large side dams reduce aerodynamic lift at speed while keeping the centre of pressure close to the chassis. Raised dividers and fang-shaped support brackets add targeted stiffness without significant mass increase, maintaining predictable handling through high-speed sections.

Constructed from a high-performance composite blend, the wing offers higher impact resistance compared with thin lexan parts while still prioritising low weight to limit changes to suspension and roll behaviour. Pre-marked cutting holes allow controlled reduction of surface area to tune rear downforce for different tracks and tyre choices.

Compatibility is broad by design, intended for use on 1/8 off-road buggies and truggies that accept standard wing mounts; confirm mount spacing on your chassis before fitment. Installation requires common mounting hardware and basic trimming tools, and adjustments to downforce are achieved by following the marked cut points to remove or retain sections.

Choose this wing when you want a low-profile, impact-resistant rear aero surface that can be trimmed and mounted to fine-tune downforce for racing conditions.