1/10 Touring and Drift Turnbuckle Wrench 8mm Steel - Yokomo YT-303  [YT-303]

Yokomo YT-303 Steel Wrench (8mm)
Price:
CAD$14.90
Brand:
Yokomo
Model:
YT-303
GTIN:
639342230655
Condition:
Brand New
Write a review

Slim 8mm steel spanner for precise turnbuckle tuning

This 8mm steel wrench is made as a compact setup tool for turnbuckles, rod ends and small hex nuts commonly used on 1/10 touring and drift chassis. The fixed 8mm face maintains solid engagement on hex flats for fine suspension and toe adjustments.

Typical use: ideal for setup and maintenance tasks like adjusting tie-rods, correcting toe-in or toe-out, and trimming small alignment changes after swapping components. Hold the mating nut while turning to isolate torque and avoid twisting suspension links.

Care tips: wipe the contact faces after running and keep the wrench in a tool pouch to avoid loss. Inspect for burrs or deformation regularly to preserve accurate engagement. This is an RC chassis setup accessory not intended for full-size vehicle use.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

What 1/10 cars use 8mm turnbuckle nuts?

Most 1/10 touring and drift models use standard 8mm turnbuckle nuts on tie-rods and some suspension links, so this wrench covers a wide range of common setups.

How do I avoid twisting suspension during adjustments?

Support the opposite nut or the chassis while you turn the wrench, and make small incremental turns to keep loads low and alignment accurate.

Any storage or maintenance suggestions?

Keep it dry after events, store in a pouch with your setup tools, and check for nicks that can damage nut flats; replace if the face becomes deformed.

Copyright © 2008-2026 rcjaz.ca All rights reserved