The Kyosho FATH710BKD is supplied as a pair of premounted FD2 drift tires fitted to black 8-spoke Watanabe-style wheels, sold as a 2pc set. It delivers a plug-and-play wheel and tyre option for 1/10 on-road drift chassis so you can skip separate mounting steps.
Fitting is straightforward for common 1/10 drift hubs: remove the existing wheel nuts, slide the wheel onto the hub, and tighten using your car's factory hardware. Always confirm hex size and wheel clearance before final installation, and check that the wheel offset matches your chassis to avoid contact with suspension parts or bodywork.
On-track, the premounted FD2 tyres act as a tuning component, changing breakaway behavior and slide control. Try adjustments to steering angle, suspension preload, and weight distribution to find a setup that complements these tyres. Check wheel balance and runout and keep wear matched across an axle for consistent drift lines.
Maintenance is simple: inspect wheels and tyres after each session, clean rubber surfaces with a mild solvent if grip shifts, and ensure wheel nuts are torqued to prevent loosening. Store away from direct heat and sunlight to protect the rubber compound.
Copyright © 2008-2026 rcjaz.ca All rights reserved
