1/10 EP Buggy Front Shock Shaft 44mm (2pcs) - Kyosho W5303-14B  [KY-W5303-14B]

Install-ready front shock shaft for 1/10 EP buggies

This Kyosho W5303-14B Shock Shaft (44/2pcs) is a direct-scale RC accessory intended for 1/10 electric powered (EP) buggies to alter front shock travel. The listing indicates a 44mm shaft provided as a set of 2pcs and specifically notes the front shaft is 2mm longer than the W5184-04 front shaft, making it useful when you need additional travel or different shock stroke characteristics without changing shock bodies.

Compatibility and role: Designed for front shocks on 1/10 EP buggy setups, the extra 2mm length primarily affects maximum compression and extension range, allowing hobbyists to fine-tune handling by pairing the shaft length change with spring rates and ride height adjustments. This part is intended as a replacement or tuning option within the RC scale suspension system.

Installation notes: Replacement requires disassembling the front shock to remove the original shaft and reinstalling the W5303-14B shaft into the existing shock assembly, reusing your current springs, pistons, and oil unless a full rebuild is planned. After replacement, cycle the shock to check for smooth travel, confirm there is no binding, and verify mounting clearances at full droop and full compression.

Tuning guidance: Use the longer shaft when you want marginally increased travel or altered mid-travel feel; combine with suitable spring and damper adjustments to balance bottoming resistance and response. Because this is a scale RC part, small length changes can noticeably change handling—test in small steps and record settings.

This W5303-14B shaft set provides a simple, reversible way to modify front shock travel on 1/10 EP buggies and is intended for model-level suspension tuning rather than any full-system overhaul.