XRAY 372925 X10 Left Aluminum Rear Bulkhead for 1-Piece Chassis  [XR-372925]

Price:
CAD$66.79
Brand:
XRAY
Model:
XR-372925
Condition:
Brand New
Write a review

Stiffen Your XRAY X10 with a Precision Aluminum Left Bulkhead

The XRAY 372925 X10 Aluminum Rear Bulkhead is a meticulously made left-side component for 1-piece chassis designs. Machined from quality aluminum, it increases durability and keeps suspension geometry consistent so your car stays predictable during aggressive laps and frequent running.

Advantages of Aluminum Construction

Aluminum delivers an excellent strength-to-weight balance, cutting down flex without adding excessive mass. Swapping the stock part for this aluminum bulkhead reduces deformation under load and helps your chassis retain setup settings over time.

Fitment Notes for 1-Piece Chassis

This rear bulkhead is made to suit the XRAY X10 series and installs cleanly on single-piece chassis layouts. Its precise tolerances make assembly straightforward and minimise setup time so you can get back on track quickly.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will this part fit older X10 variants?

Check your chassis revision against XRAY documentation, but this bulkhead is intended for current XRAY X10 series 1-piece chassis layouts and most compatible revisions.

Do I need special tools to install it?

Installation uses standard hex drivers and common RC tools; light threadlocker is recommended on hardware to keep screws secure under race conditions.

How should I maintain the aluminum bulkhead?

Wipe off grit after runs, inspect mounting points for wear and retighten screws as needed. A quick visual check before events prevents surprises on the track.

Copyright © 2008-2025 rcjaz.ca All rights reserved